🌿 Siser EasyWeed®, EasyWeed® Electric, EasyWeed® Glow in the Dark, EasyPatterns® Plus – Application Instructions

👕 Compatible Fabrics:

• 100% Cotton.
  
• Poly/cotton blends.
  
• 100% Polyester.
  
• Leather.
  

🔥 Heat Press Application:

• Preheat garment for 2–3 seconds to remove moisture and wrinkles.
  
• Apply design at 305°F (150°C).
  
• EasyPress® users should increase temperature by approximately 30°F.
  
• Press with medium pressure for 10–15 seconds.
  
• Peel carrier hot or cold.
  

🧺 Home Iron Application:

• Set iron dial between Cotton and Linen settings.
  
• Cover the design with a heat transfer cover sheet or multipurpose paper.
  
• Place garment on a flat, hard surface (ironing board not recommended).
  
• Press iron with medium to firm pressure for 10–15 seconds.
  
• Peel carrier hot or cold.
  

🧼 Laundering Instructions:

• Wait 24 hours before the first wash.
  
• Machine wash warm or cold with mild detergent.
  
• Wash garments inside out for best results.
  
• Do not bleach, dry clean, or use liquid fabric softener.
  
• Dry on a normal dryer setting.
  

⚡ Siser EasyWeed Electric Cutter Settings

Use these recommended cutter settings to achieve smooth, accurate cuts with Siser EasyWeed Electric heat transfer vinyl. Always do a test cut first to dial in the perfect result for your machine. ✂️

🎯 Recommended Machine Settings

• 🖨️ Cricut Explore Air / Cricut Maker: AutoBlade, Setting: Vinyl+ / Iron‑On
• ✂️ Silhouette Cameo (4 & 5): AutoBlade, Material: Heat Transfer Smooth, Force: ~6, Speed: ~8
• 🧩 Brother ScanNCut DX: Standard Blade, Cut Speed: ~5, Half‑Cut: Auto

💡 Cutting Tips

• 🔄 Mirror your design before cutting — this is HTV, not adhesive vinyl. :contentReference[oaicite:0]{index=0}
• 📏 Load vinyl with the colored/shiny side down and the carrier on top. :contentReference[oaicite:1]{index=1}
• 🔪 Use a fresh blade — a dull blade can drag or skip. :contentReference[oaicite:2]{index=2}
• 🐢 Slow down speed for detailed or small designs. :contentReference[oaicite:3]{index=3}
• ⚖️ Adjust force/pressure slightly if cuts are too light or too deep. :contentReference[oaicite:4]{index=4}
• ✅ Always perform a small test cut before cutting your full design. :contentReference[oaicite:5]{index=5}

These settings help ensure clean weed lines, minimal carrier damage, and professional‑looking results every time. 🎨